Low Battery After 2GIG Take345 Install

DIY Home Security Forums Support Low Battery After 2GIG Take345 Install

Tagged: 

This topic contains 2 replies, has 2 voices, and was last updated by Jason Jason 2 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #175786

    stlwx21
    Participant

    I am getting a low battery notification on the 2GIG Panel after the I had the Take345 wireless module installed. It occurs on various zones depending on what door is open. I replaced the 12 volt backup battery and rebooted the 2GIG panel, but the error returned.

    I read a few reviews stating these 2GIG Take modules can sometimes do this, but I was at least willing to give it a shot.

    Any suggestions? Please advise!

    Thanks

    #175804

    stlwx21
    Participant

    Does an end of low life battery notification mean everything is fine now? I let it sit overnight about 12 to 14 hours after changing the 12 volt battery.

    #176080
    Jason
    Jason
    Surety

    The issue that comes up when installing a TAKE is due to the order of booting up devices usually. You will want to always reboot the Alarm panel after powering up the TAKE.

    If the low battery alert went away on its own, the issue would be resolved, yes.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.