2Gig Takeover Switch

stlwx21 · January 30, 2019, 10:38am

I want to use the 2GIG TAKE345 module to take over a DSC 1616 six zone wired system.

Does anyone have some detailed, step-by-step easy to follow instructions on how to do this?

I’d rather not pay someone to come out and do this if at all possible.

jwcsurety · January 30, 2019, 10:41am

The video below shows the steps for installation and programming of the TAKE-345. The example board used in the video is actually a PC1616.

stlwx21 · January 30, 2019, 10:50am

I’ve seen that video before, but I was looking for written/electronic instructions on how to do it. I’ll look it over again though.

Thanks

jwcsurety · January 30, 2019, 11:09am

A detailed wiring diagram and instructions for installation are found in the product manual here. See page two at the top for a diagram showing how you would reuse the existing panel for power.